Integrated Solar Hot Water Heater Working Principles:

The compact solar water heaters relies on the natural circulation of water between the collector and the tank or heat exchanger.
As water in the vacuum tubes is heated it rises naturally into the tank, while cooler water in the tank flows down to the bottom of the vacuum tubes, causing circulation throughout the system.
Compact Solar Water Heater relies on density of the water, cold water down, hot water up.
To circulate water through the collectors and the tank.
When water in the collectors is heated up, it becomes lighter and naturally rises into the tank.
Meanwhile, cooler water in the tank flows down to the collectors.

In this type of installation, the tank must be together with the collectors.
These systems are reliable and relatively inexpensive but be careful with the installation.
Because the water tank is much heavier than that you thought.

Compact Solar Water Heater can work without circulating pump.
When the aid electric breaks down, it can’t affect the working of the whole system.
It makes the systems generally more reliable, easier to maintain, and has a long living life.
This type much cheaper than the others, but are also generally less efficient due to slower water flow rates through the system.

 

Integrated Solar Hot Water Heater Features:

◎ Cheap and reliable solution, Simple structure, Easy installation
◎ High efficiency
◎ Withstands water pressure no more than 0.1MPa
◎ Operated without any power supplying
◎ Electric heater can be used 1500W or 3000W
◎ Hot water can be used directly, or can be used as preheating for other systems.

 

Integrated Solar Hot Water Heater Specification:

⊙ Material of inner water tank: 0.31mm,/ o.4mm/ 0.5mm / 0.6mm, 304-2B(food-level stainless steel)
⊙ Material of outer water tank: stainless steel 0.31mm, 0.4mm, 0.5mm
⊙ Heat preservation: 55mm imported PU
⊙ Vacuum tube: single target vacuum tube, coating: AL/N/AL
⊙ Bracket: stainless steel, thickness 1.2mm/ 1.5mm
⊙ Angle of bracket: 25°, 38°, 45°
⊙ Reflector: stainless steel sheet or strip
⊙ Daily efficiency:＞50%
⊙ Optional electrical heater: 1.5kw/2kw

 

Integrated Solar Hot Water Heater Accessories:

 

1. Electric heater:1500W-2000W/220V-230V;
2. Intelligent controller: SR609(esp. for integrative pressurized type);
3. P/T valve (pressure & temperature): WAY-20,0.7MPa;
4. Magnesium rod:diameter 20/28mm, length 23~80 cm (can customize the lenght), copper connector;
5. Temperature sensor;
6. Air vent valve;
7. Vacuum valve;
8. Check valve.